Abstract：The influences of spindle speed, feed rate and radial cutting width on cutting forces were analyzed during the orthogonal plunge milling experiment of aluminum alloy. Analysis of variance was carried out and multiple linear regression equations of the cutting parameters were established at the same time. The influences of machining chatter on the signal of cutting forces were discussed. The relationships of cutting forces, tool engage angle and instantaneous chip thickness were analyzed which contributes to dividing the cutting zone into squeezing area, scratching area and cutting area.
周井文，秦文津，任培强. 铝合金插铣加工切削力分析及成屑弧区划分研究[J]. 航空制造技术, 2020, 63(8): 54-60.
ZHOU Jingwen，QIN Wenjin，REN Peiqiang. Research on Cutting Force and Partition of Chip-Forming Area During Plunge Milling of Aluminum Alloy. Aeronautical Manufacturing Technology, 2020, 63(8): 54-60.
2020, 
