[1] 刘献礼.聚晶立方氮化硼刀具及其应用.哈尔滨:黑龙江科学技术出版社,1999: 20-50.
[2] 李海波,张弘弢,董海,等.基于切削力的PCBN复合片表面摩擦系数研究.金刚石与磨料磨具工程,2008,1: 63-67.
[3] 张京英, 于启勋, 庞思勤. PCBN刀具切削力及摩擦系数试验研究. 航空制造技术,2009(12): 70-73.
[4] Shi J, Liu C R. On predicting chip morphology and phase transformation in hard machining. The International Journal of Advanced Manufacturing Technology, 2005,27(7-8): 645-654.
[5] Liu X L,Wen D H.Experimental study on hard turning hardened GCr15 steel with PCBN tool.Journal of Materials Processing Technology,2002(129): 217-221.
[6] Cappellini C, Attanasio A. Formation of white and dark layers in hard cutting: influence of tool wear. International Journal of Material Forming, 2010,3(S1): 455-458.
[7] 曹永泉,张弘弢,董海,等.PCBN刀具切削淬硬钢GCr15的磨损实验研究.中国机械工程,2006,21(17): 2305-2308.
[8] Ghani M U, Abukhshim N A. An investigation of heat partition and tool wear in hard turning of H13 tool steel with CBN cutting tools. The International Journal of Advanced Manufacturing Technology. 2008,39(9-10): 874-888.
[9] de Oliveira A J, Diniz A E ,Ursolinob D J. Hard turning in continuous and interrupted cut with PCBN and whisker-reinforced cutting tools.Journal of Materials Processing Technology, 2009(209): 5262-5270.
[10] 佟艳娇,张弘弢,李嫚,等. PCBN刀具干车淬硬钢时倒棱前角对切削力和刀具磨损的影响. 金刚石与磨料磨具工程,2007(2): 67-70.
[11] 任帅民,李嫚,张弘弢,等.PCBN刀具断续切削淬火钢时负倒棱角度对其切削性能的影响.工具技术, 2010,6(44): 13-16.
[12] Klocke F,Kratz H.Advanced tool edge geometry for high precisionhard turning.Ann CIRP,2005,54(1): 47-50.
[13] Laino S, Sikora J A, Dommarco R C. Development of wear resistant carbidicaustempered ductile iron (CADI) . Wear, 2008, 265: 1-7.
[14] 郭超,王爱玲,王子恒,等.高铬铸铁切削中刀具及切削用量优化研究.现代制造工程,2009,10: 69-72.
[15] 神会存,宗万栓,刘书锋.整体PCBN刀具高速切削高合金铸铁类材料的研究.机械制造, 2009, 539(47): 53-55.
[16] 朱从荣,王魄.整体PCBN刀片高速切削灰铸铁的研究.现代制造工程,2002,(5): 31-33.