[1] 陈光. GE公司的低转速研究用压气机与涡轮试验器. 燃气涡轮实验与研究，1995(4)：1-3.
[2] Wister D C, Halstead D E, Beacher B F. Improving compressor and turbine performance through cost-effective low-speed testing. Florence,Italy:14th International symposium on air breathing engines,sept.1999: 99-7073.
[3] 马浩军，胡广洪，阮雪榆. 利用MofdRow软件分析解决注塑件翘曲问题.模具技术，2002(5):57-59.
[4] Babur O T, Tuncay E. Determination of effecting dimensional parameters on warpage of thin shell plastic parts using integrated response surface method and gegetic algorithm. International communications in heat and mass transfer, 2005(32): 1085-1094.
[5] Hghoneim, Cahieber. Incorporation of density relaxation in the analysis of residual stresses in molded parts. Polymer Engineering and Science,1997,37(1):219-227.
[6] Tuncay E, Babur O. Minimization of warpage and sink index in injection-molded thermoplastic parts using Taguchi optimization method. Materials and Design, 2006(27): 853-861.
2013, 
