|
|
|
| Influences of Tool Path on Machining Deformation of Trapezoidal Frame Thin-Walled Parts |
| YANG Dong1, YI Liyang1, CHEN Jianbin2 |
1. Anhui University, Hefei 230601, China;
2. Anhui Tianhang Mechanical & Electrical Co., Ltd., Wuhu 241000, China) |
|
|
|
|
Abstract Integral thin-walled structural parts are widely used in the aerospace field. However, the stiffness of the thin-walled parts is poor, and machining deformation is easy to occur, resulting in low production efficiency and product qualification rate. In order to control the machining deformation of the trapezoidal frame thin-walled parts, the effects of inside-out, outside-in, parallel and zigzag tool paths on machining deformation were studied by using Python scripts and element birth-death technique-based simulation method. Simulation and experimental results show that small machining deformation can be obtained by using the outside-in path. In addition, under the strategy of outside-in tool path, cutting from the small end of the workpiece can reduce the maximum machining deformation and average deformation of the workpiece. Finally, an optimized tool path strategy for machining deformation control of the trapezoidal frame thin-walled parts was recommended.
|
|
|
|
|
|
|
|
|
2022, 
